Texas Instruments PLUS TI-89 - Manual (Page 278)

Chapter 16: Statistics and Data Plots 261
16STATS.DOC TI-89/TI-92 Plus: Statistics and Data Plots (English) Susan Gullord Revised: 02/23/01 1:12 PM Printed: 02/23/01 2:17 PM Page 261 of 22
From the Calculate dialog box ( ‡), highlight the current setting for
the Calculation Type and press B.
You can then select from a
menu of available types.
Calc Type Description
OneVar One-variable statistics — Calculates the statistical
variables described on page 263.
TwoVar Two-variable statistics — Calculates the statistical
variables described on page 263.
CubicReg Cubic regression — Fits the data to the third-order
polynomial
y=ax ò +bx ñ +cx+d . You must have at least
four data points.
¦ For four points, the equation is a polynomial fit.
¦ For five or more points, it is a polynomial regression.
ExpReg Exponential regression — Fits the data to the model
equation
y=ab õ (where a is the y-intercept) using a least-
squares fit and transformed values x and ln(y) .
LinReg Linear regression — Fits the data to the model y=ax+b
(where a is the slope, and b is the y-intercept) using a
least-squares fit and x and y .
LnReg Logarithmic regression — Fits the data to the model
equation
y=a+b ln(x) using a least-squares fit and
transformed values ln(x) and y .
Logistic Logistic regression — Fits the data to the model
y=a/(1+b*
e ^(c*x))+d and updates all the system
statistics variables.
Statistical Calculation Types
As described in the previous section, the Calculate dialog box
lets you specify the statistical calculation you want to perform.
This section gives more information about the calculation
types.
Selecting the
Calculation Type
Note: For TwoVar and all
regression calculations, the
columns that you specify for
x and y (and optionally, Freq
or Category) must have the
same length.
If an item is dimmed, it is not valid
for the current Calculation Type.