Texas Instruments PLUS TI-89 - Manual (Page 293)

276 Chapter 17: Programming
17PROGRM.DOC TI-89/TI-92 Plus: Programming (English) Susan Gullord Revised: 02/23/01 1:14 PM Printed: 02/23/01 2:18 PM Page 276 of 40
Steps
³
TI . 89
Keystrokes
›
TI . 92 Plus
Keystrokes Display
1. Start a new program on the
Program Editor.
O 7 3 O 7 3
2. Type PROG1 (with no spaces) as
the name of the new program
variable.
D D
P R O G j 1 D D
P R O G 1
3. Display the “template” for a new
program. The program name,
Prgm , and EndPrgm are shown
automatically.
After typing in an input box such as
Variable, you must press
¸ twice.
¸ ¸ ¸ ¸
4. Type the following program
lines.
Request "Enter an
integer",n
Displays a dialog box that
prompts “Enter an integer”, waits
for the user to enter a value, and
stores it (as a string) to variable n.
expr(n)! n
Converts the string to a numeric
expression.
0! temp
Creates a variable named temp
and initializes it to 0.
For i,1,n,1
Starts a For loop based on
variable i. First time through the
loop, i = 1. At end of loop, i is
incremented by 1. Loop continues
until i > n.
temp+i! temp
Adds current value of i to temp.
EndFor
Marks the end of the For loop.
Disp temp
Displays the final value of temp.
Type the
program lines
as shown.
Press ¸
at the end of
each line.
Type the
program lines
as shown.
Press ¸
at the end of
each line.
Preview of Programming
Write a program that prompts the user to enter an integer, sums all integers from 1 to the
entered integer, and displays the result.