Texas Instruments PLUS TI-89 - Manual (Page 235)

218 Chapter 12: Additional Graphing Topics
12ADDLGR.DOC TI-89/TI-92 Plus: Additional Graphing Tools (English) Susan Gullord Revised: 02/23/01 1:03 PM Printed: 02/23/01 2:15 PM Page 218 of 20
When you open a graph picture, it is superimposed over the current
Graph screen. To display only the picture, use the Y= Editor to
deselect any other functions before opening the graph picture.
From the Graph screen:
1. Press ƒ and select 1:Open .
2. Select the type ( Picture ),
folder, and variable that
contain the graph picture you
want to open.
3. Press ¸.
A graph picture is a drawing object. You cannot trace any curve on a
picture.
When you press ƒ and select 1:Open , the picture is superimposed
starting at the upper-left corner of the Graph screen. If the picture
was saved from a portion of the Graph screen (page 217), it may
appear shifted from the underlying graph.
To specify which screen pixel to use as the upper-left corner, you
can use the commands listed in “From a Program or the Home
Screen” below.
Unwanted Picture variables take up calculator memory. To delete a
variable, use the VAR-LINK screen ( 2 °) as described in
Chapter 21.
To save (store) and open (recall) a graph picture, use the StoPic ,
RclPic , AndPic , XorPic , and RplcPic commands as described in
Appendix A.
To display a series of graph pictures as an animation, use the
CyclePic command. For an example, refer to page 219.
Opening a Graph
Picture
Note: If a variable name is
not shown on the dialog
box, there are no graph
pictures in the folder.
For Pictures Saved
from a Portion of
the Graph Screen
Deleting a Graph
Picture
From a Program or
the Home Screen
Important: By default, Type = GDB
(for graph database). Be sure to set
Type = Picture.