Tally Genicom Intelliprint 8026DN - Manual (Page 190)

Mar 06
7-32 TallyGenicom Intelliprint 8026DN Color Laser Printer User Guide
System Menu
System Menu
The system menu provides access to system settings. Use the following procedure to enter the
system menu:
1. Press the MENU button on the control panel.
2. Press the NEXT button until the text “System Menu” is shown on the second line of the
display.
3. Press the SELECT button to enter the system menu.
4. Press the NEXT button to move through the submenus: Factory Defaults, Display Lan-
guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, Hex Print, Toner
Low, Page Compression, and Intellifilter.
5. Press the SELECT button to enter a submenu.
Use the procedures in the following table to access and change the system settings:
SUBMENUS DEFAULT
SETTING AVAILABLE
SETTINGS PROCEDURE FOR CHANGING
SETTING
FACTORY DEFAULTS
This submenu allows you to reset
the printer to U.S. or Non-U.S.
factory defaults.
U.S. U.S.
Non-U.S. 1. Press NEXT or PREVIOUS to
toggle between U.S. and
NON-U.S.
2. Press SELECT to choose and set
the factory defaults.
DISPLAY LANGUAGE
This submenu allows you to
change the language of the
display messages.
English English
Francais (French)
Deutsch (German)
Italiano (Italian)
Espanol (Spanish) 1. Press NEXT or PREVIOUS to
scroll through the available
languages: English, French
(Francais), German (Deutsch),
Italian (Italiano), or Spanish
(Espanol).
2. Press SELECT to choose and set
the language.
POWER SAVER
This submenu allows you to
change the time (in minutes) when
the printer enters the Power Saver
Mode.
15 1 to 999 1. Press NEXT or PREVIOUS to
select the number of minutes.
2. Press SELECT to choose and set
the time.
WAIT TIMEOUT
This submenu allows you to
increase or decrease the length of
time (in seconds) that the printer
will remain in the waiting state—a
job is being processed, no
end-of-file has been detected, and
there is no more data to process.
This setting applies to both PCL
and PostScript print jobs.
00020 0 – 99999 1. Press NEXT or PREVIOUS to
increase or decrease each digit of
the five-digit number.
2. Press SELECT set one digit and
move to the next digit.
3. Press SELECT after changing the
last digit to save this setting.