Tally Genicom Intelliprint 8026DN User Manual
Page 203
Mar 06
TallyGenicom Intelliprint 8026DN Color Laser Printer User Guide
8-3
Installing DRAM Memory DIMMS
5. Remove the three screws that secure the controller assembly.
6. Remove the controller assembly.
7. Carefully insert a DRAM DIMM which is compatible with your printer into DRAM DIMM slot
as shown below. Insert at a 45 degree angle into the DRAM connector.
8. When properly seated, gently push down on the DIMM until the side braces close onto the
edges of the DIMM.
9. Reinstall the controller assembly in reverse order as shown in Steps 5 and 6.
10. Reconnect the power cord and signal cable to the printer as shown in Step 4Reinstall the
Tray 2 rear cover as shown in Step 3.
11. Turn the printer power switch to the ON [ I ] position.
1
3
2
Side
Brace
Side
Brace