For power & earth connection, For power & earth connection 6 – Tally Genicom Intelliprint 8026DN User Manual
Page 20
Feb 06
6
TallyGenicom Intelliprint 8026DN Color Laser Printer User Guide
Safety Notes
For Power & Earth Connection
Use only the power cord specified for this printer. Using a different cord may cause fire or
electric shock. Also, do not use the machine’s power cord with other equipment.
The power specifications are listed below. The specifications that apply to your machine
depend on your machine configuration. Connect the power plug only to a properly rated
power outlet. Otherwise, it can cause fire or electric shock. If in doubt, contact our Customer
Support Center or your dealers.
• Rated voltage 100/120 V
Rated frequency 50/60 Hz
• Rated voltage 220/240 V
Rated frequency 50/60 Hz
Ensure that the plug connection is free of dust. In a damp environment, a contaminated
connector can draw a non-negligible amount of current that can generate heat and
eventually cause fire over an extended period of time.
Always use the power cord provided with your machine. When an extension power cord is
required, always use a properly rated cord.
• In Japan: 125 V/15 A
• In other countries: Contact our Customer Support Center or your dealers. If you use a cord
with an unspecified current rating, the machine or plug may emit smoke or become hot to
the touch externally.
Do not use any other power cords except those provided. Also, when using the power cords,
please observe the following points. Failure to do so may cause fire or electric shock:
• Do not touch the plug when your hands are wet.
• Do not spoil, damage, or make any changes to the cord.
• Do not place a heavy object on the cord or pull and overstretch it.
• Do not place the cord near a heater.
• Do not bundle or tie up the cord.
• Do not pull out the plug at all times, and do not place any object around the power plug.
If the power cord is broken or insulated wires are exposed, ask our Customer Support
Center for a replacement. Using a damaged cord can cause electric shock.
Never touch a power cord with wet hands. Danger of electric shock exists.