For machine operation, For machine operation 9 – Tally Genicom Intelliprint 8026DN User Manual
Page 23
Feb 06
TallyGenicom Intelliprint 8026DN Color Laser Printer User Guide
9
Safety Notes
For Machine Operation
Do not place any liquid container such as a vase or coffee cup on the machine. Split water
can cause fire or electric shock.
Do not place any metal parts such as staples or clips on the machine. If metal and flammable
parts get into the machine, they can short-circuit internal components, and cause fire or
electric shock.
If debris (metal or liquid) gets into the machine, switch off and unplug the machine. Contact
our Customer Support Center. Operating a debris-contaminated machine can cause fire or
electric shock.
Never open or remove machine covers that are secured with screws unless specifically
instructed in this manual. A high voltage component can cause electric shock.
Do not try to alter the machine configuration, or modify any parts. An unauthorized
modification can cause smoke or fire.
This equipment is certified as a Class 1 laser product under IEC60825-1 (Class 1). This
means that the machine does not emit hazardous laser radiation. Since radiation emitted
inside the machine is completely confined within the protective housings and external
covers, the laser beam cannot escape from the machine during any phase of user
operation. Do not perform any operation apart from the instructions given in the manual.
There may be a danger of laser beam leakage.
Do not place a magnet near the safety switch of the machine. A magnet can activate the
machine accidentally, resulting in injuries.
Never touch a labeled area found on or near the heat roller. You can get burnt. If a sheet of
paper is wrapped around the heat roller, do not try to remove it by yourself to avoid injuries
or burns. Switch off the machine immediately, and contact our Customer Support Center or
your dealers.
Do not place any heavy object on the machine. An off-balance machine can fall over or the
heavy object can fall, causing injuries.
Do not use a highly flammable spray or solvent near the machine. It can cause fire.