TANDBERG Security Camera - Manual (Page 116)

116
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
URI Dialing
URI Dialing for Outgoing Calls
When dialing by URI, the hop count
used is that configured for the DNS
zone that matches the URI address.
If there is no DNS zone configured that
matches the URI address, then the query may
be forwarded to a neighbor. In this case, the
hop count used will be that configured for the
neighbor zone.
Adding and Configuring DNS Zones
In order for locally registered endpoints to
use URI dialing through the VCS, you must
configure at least one DNS zone. To do this:
VCS Configuration > Zones • .
You will be taken to the Zones page.
Click New .
You will be taken to the Create Zone page.
Enter a Name for the zone and select a Type
of DNS .
Click Create Zone .
You will be taken to the Edit Zone page.
xCommand ZoneAd • d
xConfiguration Zones Zone [1..200 • ]
Name
Assigns a name to this zone.
Type
For DNS zones, this will be DNS .
Hop count
Specifies the hop count to be used when
sending an alias search request to this zone. If
the search request was received from another
zone and already has a hop count assigned,
the lower of the two values will be used.
H.323 mode
Determines whether or not H.323 calls will be
allowed to this zone.
SIP mode
Determines whether or not SIP calls will be
allowed to this zone.
Normal zone pattern matching and
prioritization rules will apply to DNS
zones.
Match1 - Match5
These sections allow you to specify any filtering
criteria you wish to apply to this zone.
See
Configuring Matches for DNS zones for full
information on how the Match options can be
used.