TANDBERG Security Camera - Manual (Page 139)

139
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Pipes
It is possible to control the amount of
bandwidth used on calls between specific
subzones and zones. The limits can be applied
to the total concurrent bandwidth used at any
one time, or to the bandwidth used by any
individual call.
To apply these limits, you create a pipe and
configure it with the required bandwidth
limitations. Then when configuring links
you assign the pipe to one or more links.
Calls using the link will then have the pipe’s
bandwidth limitations applied to them.
See
Applying Pipes to Links for more
information.
Creating Pipes
Name
Enter the name you wish to give to this pipe.
You will refer to this name when creating links.
Create Pipe
Click here to create the pipe and return to the
Pipes page.
About Pipes
To create a pipe:
VCS Configuration > Bandwidth > Pipes • .
You will be taken to the Pipes page.
Select New .
You will be taken to the Create Pipe page.
xCommand PipeAd • d
Bandwidth restriction
Determines whether there is a limit on the total
concurrent bandwidth of this pipe.
Unlimited : no limitations are in place.
Limited : there is a limit in place; you must
enter the limit in the field below.
NoBandwidth : there is no bandwidth available.
Total bandwidth limit (kbps)
Sets the limit on the total concurrent
bandwidth of this pipe.
Bandwidth restriction
Determines whether there is a limit on the
bandwidth of individual calls via this pipe.
Unlimited : no limitations are in place.
Limited : there is a limit in place; you must
enter the limit in the field below.
NoBandwidth : there is no bandwidth available.
Per call bandwidth limit (kbps)
Sets the limit on the bandwidth of individual
calls via this pipe.