TANDBERG Security Camera - Manual (Page 213)

213
D14049.03
MAY 2008
Grey Headline (continued)
Zones Zone [1..200] TraversalServer H323 H46019 Demultiplexing Mode: <On/Off>
Determines whether the VCS will operate in Demultiplexing mode for calls from the traversal client.
On : allows use of the same two ports for all calls.
Off : Each call will use a separate pair of ports for media.
Default: Off
Example: xConfiguration Zones Zone 3 TraversalServer H323 H46019 Demultiplexing Mode: Off
Zones Zone [1..200] TraversalServer H323 Port: <1024..65534>
Specifies the port on the VCS being used for H.323 firewall traversal from this traversal client.
Default: 6001, incrementing by 1 for each new zone.
Example: xConfiguration Zones Zone 3 TraversalServer H323 Port: 2777
Zones Zone [1..200] TraversalServer H323 Protocol: <Assent/H46018>
Determines which of the two firewall traversal protocols will be used for calls to and from the traversal client.
Note: the same protocol must be set on the client for calls to and from this traversal server.
Default: Assent
Example: xConfiguration Zones Zone 3 TraversalServer H323 Protocol: Assent
Zones Zone [1..200] TraversalServer SIP Port: <1024..65534>
Specifies the port on the VCS being used for SIP firewall traversal from this traversal client.
Default: 7001, incrementing by 1 for each new zone.
Example: xConfiguration Zones Zone 3 TraversalServer SIP Port: 5060
Zones Zone [1..200] TraversalServer SIP Transport: <TCP/TLS>
Determines which of the two transport types will be used for SIP calls between the traversal client and VCS.
Default: TCP
Example: xConfiguration Zones Zone 3 TraversalServer SIP Transport: TCP
Zones Zone [1..200] TraversalServer TCPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which the traversal client will send a TCP probe to the VCS once a call is established, in order to keep the firewall’s NAT bindings open.
Default: 20
Example: xConfiguration Zones Zone 3 TraversalServer TCPProbe KeepAliveInterval: 20
Zones Zone [1..200] TraversalServer TCPProbe RetryCount: <1..65534>
Sets the number of times the traversal client will attempt to send a TCP probe to the VCS.
Default: 5
Example: xConfiguration Zones Zone 3 TraversalServer TCPProbe RetryCount: 5
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Command Reference - xConfiguration