TANDBERG Security Camera - Manual (Page 153)

153
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Configuring the VCS as a Traversal Client
Configuring a Traversal Client Zone
VCS Configuration > Zones • .
You will be taken to the Zones page.
Click on the name of the zone you wish to
configure.
You will be taken to the
Edit Zone page.
xConfiguration Zones Zon • e [1..200]
xConfiguration Zones Zon • e [1..200]
Traversal Client
Retry interval
Specifies the interval in seconds with which a
failed attempt to establish a connection to the
traversal server should be retried.
H.323 mode
Determines whether H.323 calls will be allowed
to and from this zone.
H.323 port
Specifies the port on the traversal server to be
used for H.323 firewall traversal calls.
H.323 protocol
Determines which of the two firewall traversal
protocols to use for calls to the traversal
server.
SIP mode
Determines whether SIP calls will be allowed to
and from this zone.
SIP port
Specifies the port on the traversal server to be
used for SIP calls from this VCS.
SIP transport
Determines which transport type will be used
for SIP calls to and from the traversal server.
Primary address
Specifies the IP address or FQDN of the
traversal server.
Alternate 1..5 Address
Specifies the IP addresses or FQDNs of any
alternates configured on the traversal server. Remember to Save your changes.
Hop count
Specifies the hop count to be used when
querying this zone.
Authentication username
This field displays the Authentication username
that has been configured on this VCS. The
Authentication username and password are
system-wide settings that are used for all
Traversal Client Zones. The Authentication
username cannot be edited directly from this
page but it is shown here for reference as it
is needed when configuring the corresponding
Traversal Server Zone.
To edit the Authentication username, click on
the
Edit Authentication Username/Password
link. This will take you to the Authentication
page, where you can edit the settings under
the
External Registration Credentials section.