Xconfiguration call service, Xconfiguration call services fallback alia, Xconfiguration error reports – TANDBERG Security Camera User Manual

Page 194: Command reference - xconfiguration

Advertising

194

D14049.03
MAY 2008

Grey Headline (continued)

Bandwidth Pipe [1..100] Bandwidth PerCall Mode: <Limited/Unlimited/NoBandwidth>

Determines whether or not this pipe is limiting the bandwidth of individual calls.

NoBandwidth

: no bandwidth available. No calls can be made on this pipe.

Default: Unlimited

Example:

xConfiguration Bandwidth Pipe 1 Bandwidth PerCall Mode: Limited

Bandwidth Pipe [1..100] Bandwidth Total Limit: <1..100000000>

If this pipe has limited bandwidth, sets the maximum bandwidth (in kbps) available at any one time on the pipe.
Default: 500000

Example:

xConfiguration Bandwidth Pipe 1 Bandwidth Total Limit: 1024

Bandwidth Pipe [1..100] Bandwidth Total Mode: <Limited/Unlimited/NoBandwidth>

Determines whether or not this pipe is enforcing total bandwidth restrictions.

NoBandwidth

: no bandwidth available. No calls can be made on this pipe.

Default: Unlimited

Example:

xConfiguration Bandwidth Pipe 1 Bandwidth Total Mode: Limited

Bandwidth Pipe [1..100] Name: <S: 1, 50>

Assigns a name to this pipe.

Example:

xConfiguration Bandwidth Pipe 1 Name: "512Kb ASDL"

Call Services CallsToUnknownIPAddresses: <Off/Direct/Indirect>

Determines the way in which the VCS will attempt to call systems which are not registered with it or one of its neighbors.

Direct

: Allows an endpoint to make a call to an unknown IP Address without the VCS querying any neighbors. The call setup would occur just as it would if the far end were registered directly

to the local system.

Indirect

: Upon receiving a call to an unknown IP Address, the VCS will query its neighbors for the remote address and if permitted will route the call through the neighbor.

Off

: Endpoints registered directly to the VCS may only call an IP Address of a system also registered directly to that VCS.

Default: Indirect

Example:

xConfiguration Call Services CallsToUnknownIPAddresses: Indirect

Call Services Fallback Alias: <S: 0, 60>

Specifies the alias to which incoming calls are placed for calls where the IP Address or domain name of the VCS has been given but no callee alias has been specified.

Example:

xConfiguration Call Services Fallback Alias: "[email protected]"

Error Reports Mode: <On/Off>

Determines whether the VCS will automatically send details of application failures to a specified web service.
Note: You must restart the system for any changes to take effect.

Example:

xConfiguration Error Reports Mode: Off

TANDBERG

VIDEO COMMUNICATIONS SERVER

ADMINISTRATOR GUIDE