TANDBERG Security Camera - Manual (Page 185)

185
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
DNS Configuration
This section gives examples of DNS configuration using
Microsoft DNS Server and BIND 8 & 9.
In these examples we show how to set up an SRV record to
handle H.323 URIs of the form
[email protected] . These are
handled by the system with the fully qualified domain name of
vcs.example.com which is listening on port 1719, the default
registration port.
Using Microsoft DNS Server you can add the SRV record using either the command line or the MMC snap-in.
To use the command line, on the DNS server open a command window and enter:
dnscmd . /RecordAdd domain service _ name SRV Priority Weight Port Target •
where:
domain is the domain into which you wish to insert the record
service _ name is the name of the service you’re adding
Priority is the priority as defined by RFC 2782 [3]
Weight is the weight as defined by RFC 2782 [3]
Port is the port on which the system hosting the domain is listening
Target is the FQDN of the system hosting the domain
For example:
dnscmd . /RecordAdd example.com _ h323ls. _ udp SRV 1 0 1719 vcs.example.com •
Verifying the SRV Record
There are a range of tools available to investigate DNS records.
One commonly found on Microsoft Windows and UNIX platforms
is
nslookup . Use this to verify that everything is working as
expected.
For example:
nslookup -querytype=srv _ h323ls. _ udp. •
example.com
and check the output.
BIND is a commonly used DNS server on UNIX and Linux systems. Configuration is based around two sets of text files: named.conf
which describes which zones are represented by the server, and a selection of zone files which describe the detail of each zone.
BIND is sometimes run chrooted for increased security. This gives the program a new root directory, which means that the
configuration files may not appear where you expect them to be. To see if this is the case on your system, run
ps aux | grep named •
This will give the command line that named (the BIND server) was invoked with. If there is a -t option, then the path following that is
the new root directory and your files will be located relative to that root.
In
/etc/named.conf look for a directory entry within the options section. This will give the directory in which the zone files are
stored, possibly relative to a new root directory. In the appropriate zone section, a file entry will give the name of the file containing the
zone details.
Overview Microsoft DNS Server
BIND 8 & 9
It is assumed that both A and AAAA records already exist
for
vcs.example.com . If not, you will need to add one.
For more details of how to configure BIND servers and the DNS system in general see the publication DNS and BIND [6] .