TANDBERG Security Camera - Manual (Page 212)

212
D14049.03
MAY 2008
Grey Headline (continued)
Zones Zone [1..200] TraversalClient H323 Port: <1024..65534>
Specifies the port on the traversal server to be used for H.323 firewall traversal calls from this VCS. If your traversal server is a VCS Expressway, this must be the port number that has been
configured in the Traversal Server zone for this VCS.
Default: 2777
Example: xConfiguration Zones Zone 2 TraversalClient H323 Port: 2777
Zones Zone [1..200] TraversalClient H323 Protocol: <Assent/H46018>
Determines which of the two firewall traversal protocols will be used for calls to and from the traversal server.
Note: the same protocol must be set on the server for calls to and from this traversal client.
Default: Assent
Example: xConfiguration Zones Zone 2 TraversalClient H323 Protocol: Assent
Zones Zone [1..200] TraversalClient Primary Address: <S: 0, 128>
Specifies the IP Address or Fully Qualified Domain Name (FQDN) of the traversal server.
Example: xConfiguration Zones Zone 2 TraversalClient Primary Address: "10.192.168.1"
Zones Zone [1..200] TraversalClient RetryInterval: <1..65534>
Specifies the interval (in seconds) with which a failed attempt to establish a connection to the traversal server should be retried.
Default: 120
Example: xConfiguration Zones Zone 2 TraversalClient RetryInterval: 120
Zones Zone [1..200] TraversalClient SIP Port: <1024..65534>
Specifies the port on the traversal server to be used for SIP calls from this VCS. If your traversal server is a VCS Expressway, this must be the port number that has been configured in the
Traversal Server zone for this VCS.
Default: 5060
Example: xConfiguration Zones Zone 2 TraversalClient SIP Port: 5060
Zones Zone [1..200] TraversalClient SIP Transport: <TCP/TLS>
Determines which transport type will be used for SIP calls to and from the traversal server.
Default: TCP
Example: xConfiguration Zones Zone 2 TraversalClient SIP Transport: TCP
Zones Zone [1..200] TraversalServer Authentication UserName: <S: 1, 128>
The name used by the traversal client when authenticating with the traversal server. If the traversal client is a VCS, this must be the VCS’s Authentication User Name. If the traversal client is
a gatekeeper, this must be the gatekeeper’s System Name.
Example: xConfiguration Zones Zone 3 TraversalServer Authentication UserName: "User123"
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Headline Text Goes Here
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Command Reference - xConfiguration