TANDBERG Security Camera - Manual (Page 169)

169
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Shutting Down
Shutting Down
The system must be shut down before it is unplugged.
Once the system has been shut down, the only way it can be
restarted is by pressing the soft power button on the unit itself.
You must therefore have physical access to the unit if you wish
to be able to restart it after it has been shut down.
Shutting down will cause any active calls and registrations to
be terminated. For this reason, the
Shutdown page displays
the number of current calls and registrations, so you can check
these before you restart.
Shutdown System
Click here to shutdown the system.
The
Shutting Down page will appear. This page will remain in
place once the system has successfully shut down but any
attempts to refresh the page or access the VCS will then be
unsuccessful.
! Do not shutdown the system while the red ALM LED on
the front of the box is on. This indicates a hardware
fault. Contact your TANDBERG representative.
Overview
To shut down the VCS:
Maintenance > Shutdown • .
You will be taken to the Shutdown page.