TANDBERG Security Camera - Manual (Page 209)

209
D14049.03
MAY 2008
Grey Headline (continued)
Zones LocalZone Traversal H323 UDPProbe RetryInterval: <1..65534>
Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will send a UDP probe to the VCS.
Default: 2
Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe RetryInterval: 2
Zones LocalZone TraversalSubZone Bandwidth PerCall Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) applied to any one traversal call being handled by the VCS (applies only if Mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth PerCall Limit: 1920
Zones LocalZone TraversalSubZone Bandwidth PerCall Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth of any one traversal call being handled by the VCS.
NoBandwidth : no bandwidth available. No traversal calls can be made.
Default: Unlimited
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth PerCall Mode: Limited
Zones LocalZone TraversalSubZone Bandwidth Total Limit: <1..100000000>
Specifies the total bandwidth (in kbps) allowed for all traversal calls being handled by the VCS (applies only if Mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth Total Limit: 500000
Zones LocalZone TraversalSubZone Bandwidth Total Mode: <Limited/Unlimited/NoBandwidth>
Determines whether or not there is a limit to the total bandwidth of all traversal calls being handled by the VCS.
NoBandwidth : no bandwidth available. No traversal calls can be made.
Default: Unlimited
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth Total Mode: Limited
Zones Zone [1..200] ENUM DNSSuffix: <S: 0, 128>
Specifies the DNS zone to be appended to the transformed E.164 number to create an ENUM host name which this zone is then queried for.
Example: xConfiguration Zones Zone 1 ENUM DNSSuffix: "e164.arpa"
Zones Zone [1..200] H323 Mode: <On/Off>
Determines whether H.323 calls will be allowed to and from this zone.
Default: On
Example: xConfiguration Zones Zone 1 H323 Mode: On
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Command Reference - xConfiguration