TANDBERG Security Camera - Manual (Page 174)

174
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
CPL Reference
subfield
Within the address-switch node , the optional subfield parameter specifies which part of the address is to be considered. The following table gives the definition of subfields for each alias type.
If a subfield is not specified for the alias type being matched then the not-present action will be taken.
address-type Either h323 or sip , based on the type of endpoint that originated the call.
user For URI aliases this selects the username part. For H.323 IDs it is the entire ID and for E.164 numbers it is the entire number.
host For URI aliases this selects the domain name part. If the alias is an IP address then this subfield is the complete address in dotted decimal form.
tel For E.164 numbers this selects the entire string of digits.
alias-type Gives a string representation of the type of alias. The type is inferred from the format of the alias. Possible types are:
Address Type •
Result •
URI •
url-ID •
H.323 ID •
h323-ID •
Dialled Digits •
dialedDigits •
address-switch
The otherwise node will be executed if the address specified in the address-switch was found but
none of the preceding address nodes matched.
The not-present node is executed when the address specified in the address-switch was not
present in the call setup message. This form is most useful when authentication is being used.
With authentication enabled the VCS will only use authenticated aliases when running policy so
the
not-present action can be used to take appropriate action when a call is received from an
unauthenticated user (see the example Call Screening of Unauthenticated Users ).
otherwise not-present