Default settings for the professional access point – USRobotics Instant802 APSDK User Manual
Page 16
Professional Access Point
Administrator Guide
Pre-Launch Checklist: Default Settings and Supported Administrator/Client Platforms - 16
Default Settings for the Professional Access Point
Option
Default Settings
Related Information
System Name
USR5453-AP
“Setting the DNS Name” on
page 91 in “Ethernet (Wired) Set-
tings” on page 89
User Name
admin
The user name is read-only. It cannot be modi-
fied.
Password
admin
“Provide Administrator Pass-
word and Wireless Network
Name” on page 38 in “Basic Set-
tings” on page 35
Network Name (SSID)
USR5453 Internal Network
for the Inter-
nal interface
USR5453 Guest Network
for the Guest
interface
“Review / Describe the Access
Point” on page 37 in “Basic Set-
tings” on page 35
“Configuring Internal LAN Wire-
less Settings” on page 99 in
“Wireless Settings” on page 97
“Configuring Guest Network
Wireless Settings” on page 100
in “Wireless Settings” on page 97
Network Time Protocol (NTP)
None
IP Address
192.168.1.10
The default IP address is used if you do not
use a Dynamic Host Configuration Protocol
(
) server. You can assign a new static IP
address through the Web User Interface.
server on the network,
then an IP address will be dynamically
assigned by the server at access point startup.
“Understanding Dynamic and
Static IP Addressing on the Pro-
fessional Access Point” on
page 20
Connection Type
Dynamic Host Configuration Protocol
(
)
server on the Inter-
nal network and do not plan to use one, the
first thing you must do after bringing up the
access point is to change the connection type
from DHCP to Static IP.
The Guest network must have a DHCP server.
“Understanding Dynamic and
Static IP Addressing on the Pro-
fessional Access Point” on
page 20
For information on how to recon-
figure the Connection Type, see
“Configuring Internal Interface
Ethernet Settings” on page 93.
Subnet Mask
255.255.255.0
This is determined by your network setup and
DHCP server configuration.