USRobotics Instant802 APSDK - Manual (Page 201)

Professional Access Point
Administrator Guide
Class Structure, Commands, and Examples - 201
Field Value
--------------------
mac 00:a0:c9:8c:c4:7e
ip 192.168.1.1
mask 255.255.255.0
Get the MAC Address for the Wired Internal Interface
USR5453-AP# get interface wlan0 mac
02:0C:41:00:02:00
Get the Network Name (SSID) for the Wired Internal Interface
USR5453-AP# get interface wlan0 ssid
elliot_AP
Get Current Settings for the Ethernet (Wired) Guest Interface
The following example shows how to use the CLI to get the Ethernet (Wired) settings for the Guest
interface for an access point. You can see by the output results of the command that the MAC address is
00:50:04:6f:6f:90, the IP address is 10.10.56.248, and the subnet mask is 255.255.255.0.
USR5453-AP# get interface brguest
Field Value
--------------------
type bridge
status up
mac 00:50:04:6f:6f:90
ip 10.10.56.248
mask 255.255.255.0
Get Current Wireless (Radio) Settings
The following examples show how to use the CLI to get wireless radio settings on an access point, such as
mode, channel, and so on. You can see by the results of the commands that the access point mode is set
to IEEE
802.11g , the channel is set to 6, the beacon interval is 100, and so forth.
For information on how to configure Radio settings through the CLI, see “Radio Settings” on page 230 .
(Radio settings are fully described in “Configuring Radio Settings” on page 130 .)
Get the Current IEEE 802.11 Radio Mode
USR5453-AP# get radio wlan0 mode
g
Get the Channel the Access Point is Currently Using
USR5453-AP# get radio wlan0 channel
2
Get Basic Radio Settings for the Internal Interface
USR5453-AP# get radio wlan0
Field Value
Note
You can get specifics on the Guest interface by using the same types of commands as for the
Internal interface but substituting brguest for wlan0. For example, to get the MAC address for the
guest interface: get interface wlan0 ssid