USRobotics Instant802 APSDK - Manual (Page 172)

Professional Access Point
Administrator Guide
Upgrade - 172
2. Click the Reset button.
Factory defaults are restored.If the IP address of the access point changes after the reset, you need to
specify the new address in your Web browser in order to access the Web User Interface.
If you cannot access the Web User Interface, you can reset the access point by using a thin object,
such as a paper clip, to press the Reset button until both the LAN and WLAN LEDs turn off briefly.
Upgrade
As new versions of the Professional Access Point firmware become available, you can upgrade the
Note
Keep in mind that if you do reset the configuration from this page, you are doing so for this access
point only; not for other access points in the cluster.
For information on the factory default settings, see “Default Settings for the Professional Access Point”
on page 16.