USRobotics Instant802 APSDK - Manual (Page 285)

Professional Access Point
Administrator Guide
Installation and Connectivity Troubleshooting - 285
2. Select Never dial a connection , and then click the LAN Settings button.
3. Clear all the checkboxes and click OK .
4. Click OK again to apply the connection setting
Netscape Navigator users:
1. Click Edit , Preferences , and then double-click Advanced in the Category window.
2. Click Proxies , select Direct connection to the Internet , and then click OK .
Possible Solution 4:
Reset the access point by using a thin object, such as a paper clip, to press the Reset button until both the
LAN and WLAN LEDs turn off briefly.
I need to configure the access point with an operating system other
than Windows.
Possible Solution:
You must configure the access point through its Web User Interface as follows:
1. Find the access point’s IP address:
1) Using the configuration program for the networking device to which the access point is connected,
view the device’s client list.
2) Find the MAC address of the access point in the client list.
3) Note the IP address the corresponds to the MAC address of the access point.
2. Launch a Web browser, type the IP address of the access point in the browser’s navigation bar, and
press Enter.
3. You can now log in and perform access point configuration.
My wireless device cannot find the wireless network.
Possible Solution 1:
Move the wireless device closer to the access point. The device may be out of the access point’s range.
Note
Resetting the access point returns all settings to their factory defaults. You will have to re-enter your
configuration settings or restore your configuration backup after resetting the access point.