USRobotics Instant802 APSDK - Manual (Page 230)

Professional Access Point
Administrator Guide
Class Structure, Commands, and Examples - 230
Creating VWN 'Two' on Radio One with WPA security
To configure the second Virtual Wireless Network, repeat steps 1-3 as described above (in Configuring
Virtual Wireless Network "One" on Radio One) with the following differences:
• Create a second VLAN ID from the Web User Interface with a new SSID
• In the CLI commands, replace wlan0bssvwn1 with wlan0bssvwn2.
Radio Settings
This table shows a quick view of Radio Settings commands and provides links to detailed examples.
Get IEEE 802.11 Radio Mode
To get the current setting for radio Mode:
USR5453-AP# get radio wlan0 mode
g
Note
Before configuring this feature, make sure you are familiar with the names of the interfaces as
described in
“Understanding Interfaces as Presented in the CLI” on page 190 . The interface name you
reference in a command determines whether a setting applies to a wired or wireless interface or to the
Internal or Guest network.
Radio Setting Command Example
Get Radio Settings get radio
get radio wlan0
get radio wlan0 detail
Get IEEE 802.11 Radio Mode get radio wlan0 mode
Get Radio Channel get radio wlan0 channel
Get Basic Radio Settings get radio wlan0
Get All Radio Settings get radio wlan0 detail
Get Supported Rate Set get supported-rate
Get Basic Rate Set get basic-rate
Configure Radio Settings See detailed examples in:
“1. Turn the Radio On or Off” on page 233
“2. Set the Radio Mode” on page 233
“3. Enable or Disable Super G” on page 233
“4. Set the Beacon Interval” on page 233
“5. Set the DTIM Period” on page 233
“6. Set the Fragmentation Threshold” on page 233
“7. Set the RTS Threshold” on page 234
“8. Configure Basic and Supported Rate Sets” on page 234