USRobotics Instant802 APSDK - Manual (Page 192)

Professional Access Point
Administrator Guide
Class Structure, Commands, and Examples - 192
Basic Settings
The following CLI command examples correspond to tasks you can accomplish on the Basic Settings tab
of the Web User Interface for access points with clustering capabilities. In some cases, the CLI
get
command provides additional details not available through the Web User Interface.
This table shows a quick view of Basic Settings commands and provides links to detailed examples.
Note
Before configuring this feature, make sure you are familiar with the names of the interfaces as
described in
“Understanding Interfaces as Presented in the CLI” on page 190 . The interface name you
reference in a command determines whether a setting applies to a wired or wireless interface, or to the
Internal or Guest network.
Basic Setting Example
Get the IP Address for the Internal Inter-
face on an Access Point get interface br0 ip
or
get interface
get interface is a catch-all command that shows common information
on all interfaces for the access point such as IP addresses, MAC
addresses, and so on. The IP address for the Internal interface (and
the one used to access the access point) is that shown for br0. (See
“Understanding Interfaces as Presented in the CLI” on page 190 )
Get the MAC Address for an Access Point get interface br0 mac
Get Both the IP Address and MAC
Address get interface br0 mac ip
Get Common Information on All Interfaces
for an Access Point get interface
Get the Firmware Version for the Access
Point get system version
Get the Location of the Access Point get cluster location
Set the Location for an Access Point set system location NewLocation
For example:
set system location hallway
or
set system location " Vicky’s Office "
Get the Current Password get system encrypted-password
Set the Password set system password NewPassword
For example:
set system password admin
Get the Wireless Network Name (SSID) ) get interface wlan0 ssid