Using the usb interface – Zebra Technologies TTP 8000 User Manual
Page 19
19
Installation
Connecting to the Computer
10/19/2009
TTP 8000 Technical Manual
P1003638-003
Using the USB Interface
1.
Connect J13 of the printer to the USB port of the computer or the USB hub to be used.
USB connectors can be recognized by the following symbol:
.
2.
Connector J13 is a 4-pin USB type B connector. See
for pin assignment.
A suitable cable is available from Zebra, see
for part number.
Figure 8 • USB Cable with Type A and Type B Connectors
Note •
The USB interface on printers with hardware revision A does not trigger enumeration
in Windows when the printer is reset. Reset occurs after font, logotype, firmware and
parameter storage. This means that the printer will disappear from the list of available
printers at reset, and appear again when the PC is restarted. In normal operation this will not
happen. Powering off/on the printer starts enumeration.
You can see the hardware revision on the self-test printout.