Zebra Technologies TTP 8000 - Manual (Page 73)

73 Default Parameter Settings
How the Parameters are Described
10/19/2009 TTP 8000 Technical Manual P1003638-003
Table 10 • Summary of Parameter Settings
Parameter Description ESC&F <10> Default Page
1 Baud rate 96 (9600 Baud) page 74
2 Data bits 8 page 74
3 Parity 0 (No parity) page 74
4 Flow control 2 (Hardware) page 75
5 Disable parallel port signaling 0 (No) page 76
6 Buffer mode 0 (Spool all data before printing) page 77
7 Burn time 14 page 77
8 Print speed 13 (80mm/s for 203 dpi, 53mm/s for 300 dpi) page 78
9 Presenter loop length 10 (32 cm) page 78
13 Line spacing 0 (Auto) page 78
14 Font selection 0 (TTP Mono 9) page 78
15 to 30 Tab stop 4, 8, 12 etc. page 79
31 Pull speed 20 (1 on the vertical version of TTP 8200) page 79
33 CR/LF 0 (LF = CR/LF, CR=Ignored) page 79
34 Auto cut after FF 1 (On) page 80
36 Document mode 1 (Variable) page 80
37 & 38 Page length, Minimum / fixed / BM 4, 0 (102.4 mm) page 81
39 Max black mark length 50 (5 mm) page 82
40 Min black mark length 30 (3 mm) page 82
41 & 42 Black mark cut offset 0, 0 (0 mm) page 82
43 & 44 Top margin 0, 0 (Disabled) page 83
45 Wastebasket 3 (Eject and retract after 30 s) page 83
47 Wall Compensation 0 page 84
48 Paper width 208 mm page 84
49 Bottom margin 1 (Auto) page 85
51 Black mark level 50 (0.97 V) page 85
52 Warning level 0 (Off) page 85
53 Lock parameters 0 (Unlocked) page 86
55 PSU recovery 255 page 86
Note • When the printer is set up the way you like it to be, you send <ESC>&<4>, and all
settings will be stored.