Zebra Technologies TTP 8000 - Manual (Page 82)

Default Parameter Settings
Fixed Document Mode 82
P1003638-003 TTP 8000 Technical Manual 10/19/2009
Fixed Document Mode
Max fixed document mode page length depends on the amount of free ram. Make a self test
printout to check how much is available in your printer. (Depends on firmware version and
circuit board revision).
Paper length, top, and bottom margins are in pixel lines. Paper width is in bytes. 1 byte = 1 mm
for the TTP 8200 and one byte is 2/3 of a mm in TTP 8300.
If a too large fixed page is specified the printout will be blank from memory full to the cut.
Specifies the length of the black mark in 0.1-mm steps. Measure the length of the black mark
on your paper and enter that value here.
Marks 5 mm longer than this value are interpreted as paper out. The default value of 50 equals
5 mm.
Specifies the minimum length of the black mark in 0.1-mm steps. Shorter marks are ignored.
The default value of 30 equals 3 mm.
Defines the paper feed between the black mark detection and cut. One step is 0.1 mm.
Example • If Free RAM on a TTP 8200 is 504976 bytes, page width is 208 mm = 208 bytes,
top margin is 20 mm, and bottom margin 10 mm (20 x 8 =160 and and 10 x 8 = 80 pixel
lines):
39
50 Default
BM (Black Mark) Length
16 Min
160 Max
<ESC>&P<39><150>
Sets max black mark length to 15 mm.
40
30 Default
Min BM (Black Bark) Length “Garbage Filter”
5 Min
159 Max
<ESC>&P<40><40>
Sets min black mark length to 4 mm.
41 & 42
0 , 0 Default
BM (Black Mark) Cut Offset
0 , 0 Min
255 , 255 Max
<ESC>&P<41><1><ESC>&P<42><244>
Feeds 50 mm between black mark and
cut.
margin bottom margin top
width Paper
bytes in RAM Free
length Page − −
−
=
1024
mm lines pixel length Page 272 2182 80 160
208
1024 504976
= = − −
−
=