Zebra Technologies TTP 8000 - Manual (Page 90)

Page Setup
Parameters Used 90
P1003638-003 TTP 8000 Technical Manual 10/19/2009
Parameters Used
Parameter n34 Auto Cut
When this parameter is set to 2, "forced cut at black mark" The printer always cuts when it
detects a black mark, even if no cut command has been received. This prevents long
documents from being printed as one continuous printout over several pages.
Parameters n37 and n38 - Page Length Minimum
Measure the distance from the trailing edge of one black mark to the trailing edge of the next.
The resolution is 0.1 mm so multiply the distance by 10, then calculate the value to enter as
n37 and n38.
Parameter n39 – Max Black Mark Length
Measure the height of the black mark. The resolution is 0.1 mm so multiply the black mark
length by 10 and enter the value as n39.
Parameter n40 – Min Black Mark Length (Garbage Filter)
This parameter is actually a filter to filter out garbage on the paper. If a spot is smaller than this
value, it will not be regarded as a black mark. 1. About ? of the black mark length is usually a
suitable setting.
Example • If the page length is 200mm, (200 x 10) / 256 = 7.8125.
n37 is the integer value, that is 7, while n38 is the
fraction
0.8125 x 256 = 208