Zebra Technologies TTP 8000 - Manual (Page 53)

53 Programming
System Related Commands
10/19/2009 TTP 8000 Technical Manual P1003638-003
Redirects any parameter storage initiated by <ESC>&<4> to another storage location.
These settings can later be recalled by <ESC>&<F><n>. A reset command or power OFF/ON
will return the parameters to the default settings stored in n=10.
This command is used to load a font to the printer flash PROM. The font is placed in the first
free address position in the order of load sequence.
A Zebra font-file consists of a header containing data describing the font as well as data for
each individual character in the font.
Fonts can be designed with the font editor and loaded or deleted with the software available for
download from the Zebra web site. The font loading and deleting commands described here
should only be used if you do not work in the Windows environment.
For complete specification of the font format, see Fonts on page 64 .
Erases all fonts stored in the flash PROM.
Erases fonts number 4–7. Fonts 0–3 are not affected by this command.
The operation is complete when the printer resets automatically and activates the presenter
motor temporarily. Takes approximately 4 seconds.
ESC & 5
Set Default Profile Pointer to n
1B 26 05 n1 hex
27 38 5 n1 decimal
n = 1 – 5 Settings that can be stored by the user
n = 10 Zebra factory default setting
ESC & 0
Load Font
1B 26 00 hex
27 38 0 decimal
Note • The available font memory is printed on the self-test printout. A maximum of 8 fonts
can be addressed. Exceeding any of these limits will cause this command to fail.
ESC & C
Erase all Fonts
1B 26 43 Hex
27 38 67 Decimal
Note • This command is only executed if at least one font has been loaded.
ESC & D
Erase Fonts 4 to 7
1B 26 44 Hex
27 38 68 Decimal