Parameter, Ee parameter – Zebra Technologies TTP 8000 User Manual
Page 78
Default Parameter Settings
Print Setup
78
P1003638-003
TTP 8000 Technical Manual
10/19/2009
The main reason to decrease the print speed is to enhance print quality, and to reduce the peak
current consumption. Each step represents a 5 mm/s increase in TTP 8200 and 3.33 mm/s in
TTP 8300.
Limits the maximum loop length. When the set length is reached, the printer ejects part of the
printout and continues to print. You use this when you have very limited space for the loop
inside the kiosk. Each step represents a 3.2-cm increment.
Setting the parameter to 0 disables the looping and feeds the paper straight out.
The line spacing is normally set by the font height. With this parameter you can set a line
spacing that is higher that the font height. Line spacing settings lower than the font height will
be ignored.
Store which font number is used if no font is specified. Font is selected using
. Selecting an invalid font gives a software error status message (invalid index).
8
13 Default
Max Print Speed
DRV
1 Min
17 Max
n
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
TTP 8200
mm/s
20
25
30
35
40
45
50
55
60
65
70
75
80
85
90
95
100
TTP 8300
mm/s
13
17
20
23
27
30
33
37
40
43
47
50
53
57
60
63
67
Note •
Some settings result in printer chassis resonance causing excessive noise and
deteriorated print quality.
9
10 Default
Presenter Loop Length
3 Min
255 Max
<ESC>&P<9><0>
Disable the loop
<ESC>&P<9><7>
16 cm loop
<ESC>&P<9><10>
32 cm loop
13
0 Default
Line Spacing
0 Min
255 Max
<ESC>&P<13><30>
30 pixels or font height, whichever is the
largest
14
0 Default
Font Selection
0 Min
7 Max