Zebra Technologies TTP 8000 - Manual (Page 76)

Default Parameter Settings
Parallel Port Setup 76
P1003638-003 TTP 8000 Technical Manual 10/19/2009
Parallel Port Setup
Pins 12 and 15 on the parallel port signal paper out and error. However, in an unattended kiosk
you may not want this because it causes the host computer to stop communicating, and the
operating system may display a warning or error message on the kiosk screen.
By disabling the hardware signals, the kiosk software can for example use status commands to
find out paper level and alert appropriate personnel when the level is low, then close the kiosk
when paper is out.
5
0 Default
Disable Parallel Port Signaling
0 Min
1 Max
<ESC>&P<5><0>
No, paper out and error signals are not
disabled
<ESC>&P<5><1>
Yes, paper out and error signals are disabled
Note • When enabled, the hardware signal on pin 12 and 15 will block all communication
until the error is corrected. This means that it will be impossible to ask for status.