Zebra Technologies TTP 8000 User Manual
Page 68
Programming
Logotypes
68
P1003638-003
TTP 8000 Technical Manual
10/19/2009
Printing
To print a logotype, send <ESC>g<n1><n2><n3><n4><n5> where n1 is the logotype
number, n2n3 is the horizontal print position, and n4n5 is the vertical print position of the
upper left corner of the logotype.
Erasing
All logotypes are erased with the <ESC>&L command.
n1
One byte logotype number, (0—15)
n2n3
Two byte X position measured in pixels from the left-hand edge of the
print window.
n4n5
These bytes (Y-position) must be inserted, but they are ignored as a
logotype is always printed at the current Y-position.
Caution • Loading to the flash PROM will erase the RAM completely since the RAM is
used during the loading process. Any print data residing in RAM will thus be lost.