Default parameter settings, 6 • default parameter settings – Zebra Technologies TTP 8000 User Manual

Page 71

Advertising
background image

10/19/2009

TTP 8000 Technical Manual

P1003638-003

6

Default Parameter Settings

Some of the printer settings can be stored in the flash PROM so that they will be used also
after power OFF.

The stored parameter settings are printed out on the self-test printout (see

Self-test Printout

and Other Power ON Modes on page 29

).

The number in front of the function is the parameter number (n) used when setting the
parameter with the command <ESC>&P<n><v>.

You can use the parameter settings pretty much like normal commands. Either send the
parameter values with each printout, or set them up once and then send <ESC>&<4> to store
all settings in the flash PROM.

You can always return to factory default settings by sending <ESC>&<F><10>, and then
storing those settings with <ESC>&<4>

.

Note •

The parameters can be locked so that no changes are possible. Check parameter 53 on

the self-test printout to find out.

Note •

If you try to set a parameter to an invalid value, the parameter will be set to the

nearest valid value below.

Advertising