Zebra Technologies TTP 8000 - Manual (Page 93)

93 Page Setup
Black-mark Sensing from Within Windows
10/19/2009 TTP 8000 Technical Manual P1003638-003
Simple Calibration Process
1. Enable black mark mode by setting parameters n36 to n42 as described on the previous
pages.
2. Load paper with black marks into the printer
3. Send the <ESC># command and wait until the paper stops
4. If the paper has returned to it's original position, the calibration is finished
5. If not, it was not possible to distinguish the black mark. Check the n37 and n38 settings
and try again).
6. Save the settings with <ESC>&<4>.
Black-mark Sensing from Within Windows
Please refer to the Kiosk Driver Reference Guide, Part Number P1006873-001, available on
www.zebra.com for detailed information on Black-Mark Sensing.