Zebra Technologies EPL2 - Manual (Page 123)

W Command - Windows Mode
Description This command is used to disable/re-enable the
Windows command mode.
Syntax Wp
1
Parameters p
1
= Windows Mode Enabled.
Values = Y for enabled (default)
N for disabled
When enabled, the printer will accept Windows
mode escape sequences to print data. When
disabled, escape sequences will be ignored.
The Windows mode escape sequences are only
used by the optional Windows printer driver.
When working with a main frame or other
non-Windows host, this mode can be disabled
to prevent erratic operation.
980352-001 Rev.A
3-105