Zebra Technologies EPL2 - Manual (Page 63)

FS Command - Store Form
Description This command begins a form store sequence.
Syntax FS"FORMNAME"
Parameters “FORMNAME” =This is the form name that
will be used when retrieving the stored
form.
· The name may be up to 8 characters long.
· Form names stored by the printer are case
sensitive and will be stored exactly as entered
on the FS command line; i.e. “FORM1” ,
“form1” and “FoRm1” are three different
forms when stored into the printer or when re-
trieved by the user.
· Global commands such as EI, EK, ES, FI,
FK, GI, GK, GM, I, M, N, P, TS, U, UE,
UF, UG, Y, W, ?, ^@ should not be used in
a form store sequence.
Form name, AUTOFR , is reserved for automatic,
single form recall, see page 3-9 for details.
❏All commands following FS will be stored in
forms memory until the FE command is re-
ceived, ending the form store process.
❏Delete a form prior to updating the form by
using the FK command. If a form (with the
same name) is already stored in memory, is-
suing the FS command will result in an error
and the previously stored form is retained.
❏To print a list of the forms currently stored in
memory, use the FI command.
❏A form will not store if sufficient memory is
not allocated to form memory. See the M
command for details on adjusting and con-
figuring memory to store forms (graphics and
soft fonts).
980352-001 Rev.A
3-45