F - cut position 3-40, Command - cut position -40 – Zebra Technologies EPL2 User Manual

Page 58

Advertising
background image

f Command - Cut Position

Description Use this command on an individual printer to

provide precision cut placement.

·

Compensate sensor to cutter position differ-

ences on a printer by printer basis.

·

Fine-tune cut position to compensate for dif-

ferences in media.

Syntax

fp

1

Parameters

p

1

= Cut position index measured in dots.

Acceptable values: 070 to 130. The de-

fault value is 100.

When using the label liner cutter option, the

printer will advance each printed label to the

appropriate programmed offset cut position,

between labels, before cutting. Due to media

differences, the printer may not accurately

position the labels before cutting, causing the

cutter to cut the label instead of the liner.

The printer’s cutter is not designed to cut labels. La-

bels have adhesive that may interfere with the

proper operation of the cutter.

Only cut label liner and tag stock and do not exceed

the specified media density and thickness of the

cutter.

If the cut position causes the label just printed to

be cut, increase the cut position index value

(>100). If the cut position causes the label fol-

lowing the one just printed to be cut, decrease

the cut position index value (<100).

3-40

980352-001 Rev.A

Advertising