Xa - autosense 3-106, Command - autosense -106 – Zebra Technologies EPL2 User Manual
Page 124
Advertising
xa Command - AutoSense
Description This command is used to have the printer detect
the label and gap length and set the sensor lev-
els. This command will not enter into the Dump
mode or print the printer configuration label.
Syntax
xa¿
Example:
xa
¿
:The printer will feed labels and
: measure the labels to set the Q values
: (label & gap length) and the sensor
: levels.
: The printer is at Top of Form (TOF)
: and ready to print .
3-106
980352-001 Rev.A
Advertising