Xantrex Technology XTR 850 Watt - Manual (Page 174)

Remote Operation
5-52 975-0200-01-01
[:]OUTPut:PROTection:FOLDback[:MODE]
[:]OUTPut:PROTection:FOLDback:DELay
[:]OUTPut:POLarity
[:]OUTPut[:POWer][:STATe]
[:]OUTPut[:POWer]:PON[:STATe]
[:]OUTPut:AUXilliary[:STATe]
[:]OUTPut:AUXilliary:PON[:STATe]
[:]MEASure[:SCALar][:VOLTage][:DC]?/qonly/
[:]MEASure[:SCALar]:CURRent[:DC]?/qonly/
[:]MEASure[:SCALar]:APRogram[:VOLTage][:DC]?/qonly/
[:]MEASure[:SCALar]:APRogram[:VOLTage]:ISOLated[:DC]?/
qonly/
[:]MEASure[:SCALar]:APRogram:CURRent[:DC]?/qonly/
[:]MEASure[:SCALar]:APRogram:CURRent:ISOLated[:DC]?/
qonly/
[:]INITiate:IMMediate/nquery/
[:]CALibration:RESTore/nquery/
[:]CALibration[:VOLTage]:PROTection[:OVER][:DATA]/
nquery/
[:]CALibration:OUTPut[:VOLTage][:DATA]/nquery/
[:]CALibration:OUTPut:CURRent[:DATA]/nquery/
[:]CALibration:OUTPut:ANALog[:VOLTage][:DATA]/nquery/
[:]CALibration:OUTPut:ANALog[:VOLTage]:ISOLated[:DATA]/
nquery/
Querying Help for Legacy Command Headers
The [:]SYSTem[<channel>]:HELP:LEgacy? query is
essentially the same as the
[:]SYSTem[<channel>]:HELP:HEADers?
command, but it lists
legacy Xantrex commands. If executed it returns all Xantrex legacy
commands and queries implemented. The response shall be on a page by
page basis. No single line will be longer than 80 characters and each page
will be 23 lines long. The full path for every command and query shall be
returned separated by line feeds. After a full page of headers has been
displayed you will be prompted to press any key to continue or the ESC
key to stop any further listing of the command headers.