Printronix P7000 Cartridge Ribbon Printer - Manual (Page 114)

114
Chapter 4 NETWORK SETUP Menu
Signal Strength
This menu displays the strength of the wireless signal.
NOTE: This is a display value only and cannot be changed.
Operation Mode
Allows you to select the way the Wireless option communicates:
• Infrastructure (default). The Wireless option must go through a server.
• Pseudo IBSS . Proprietary, peer-to-peer communication (without a
server). The two peers must be specific to one manufacturer.
• Ad Hoc . Standard, peer-to-peer communication (without a server).
The two peers can be from different manufacturers.
SSID Name
A 1 - 32 character, case sensitive string that identifies the group the printer
talks to.
NOTE: The SSID name may be edited in three parts (1-15), (16-30), and
(31-32).
For each part of the SSID name, press the MICRO UP or MICRO DOWN
keys to cycle through the values available for that character at the cursor
location. Press the SCROLL UP key to move to the next character to be
modified. Press the SCROLL DOWN key to go back to the name you want to
give to this SSID name, then press ENTER to save. The name you entered
will now represent this SSID name on the printer’s front panel. To exit this
menu without saving, press any key other than the ENTER key. The SSID
name will revert to the last saved value.
Reset SSID Name
Allows you to reset the SSID name.
Min Xfer Rate
Allows you to set the minimum speed at which the Wireless Option will accept
a connection (in million bits per second). The options are:
• Auto-negotiate (default)
• 1Mb/Sec.
• 2Mb/Sec.
• 5.5Mb/Sec
• 11Mb/Sec
Channel
Allows you to select the RF channel. The options are Default (the factory
default) and 1-15.