Character set, Printer select, Esc c sequence – Printronix P7000 Cartridge Ribbon Printer User Manual
Page 193: Reset cmd cfg ld, Received cr, Received del, Private mode
193
Character Set
This parameter selects a character set for the ANSI emulation. Note that
when 0876 OCR-A or 0877 OCR-B is selected as the print language, the Font
Attributes Typeface parameter is changed to OCR-A or OCR-B, respectively.
Character sets are shown in detail in the
Character Sets Reference Manual
.
Printer Select
•
ON = DC1/OFF = DC3
(default). Disables the printer when a DC1 control
code is received, and enables the printer when a DC3 control code is
received.
•
Disable
. Ignores the DC1 and DC3 control codes.
ESC c Sequence
•
Enable
(default). An ESC c code received from the host resets the printer
parameters to the factory defaults.
•
Disable
. An ESC c code received from the host is ignored.
Reset Cmd CFG Ld
When the printer receives a host data stream reset command
(ESC @ or ESC[K) in addition to resetting printer variables, the selected
configuration will be loaded.
•
Disable
(default). The active emulation parameters are loaded when the
reset command is executed.
•
Power-Up Config
. The power-up configuration is loaded when the reset
command is executed.
•
Current Config
. The currently selected configuration is loaded when the
reset command is executed.
•
Factory Config
. The factory installed configuration is loaded when the
reset command is executed.
Received CR
•
Observe
(default). A CR code received from the host is handled as a
carriage return.
•
Ignore
. A CR code received from the host is ignored.
Received DEL
•
Observe
(default). A DEL code received from the host is handled as a
Delete command.
•
Ignore
. A DEL code received from the host is ignored.
Private Mode
Determines the default type of character set (Set 1 or Set 2). This can also be
set by ESC sequences ESC [>5h and ESC [>5l. Refer to these descriptions in
the
ANSI Programmer's Reference Manual
for further details.
ANSI Emulation