Buffer reprint, Early print cmpl, Scs buffer cntrl – Printronix P7000 Cartridge Ribbon Printer User Manual
Page 129: Cancel igp/dcu
Coax Emulation
129
PA2
PA2 is only valid when the printer is in the Offline state and the coax SCS data
stream is active. This function displays the “PA2 ENABLED” message when
the ENTER key is pressed and sends a special operator request to the host
when the printer is put back in online mode.
NOTE:
Selecting the PA2 menu item again (“PA2 DISABLED” appears on the
operator panel) or selecting the PA1 menu item will reset the pending
PA2 function.
Buffer Reprint
This option is valid only when the printer is printing in SCS mode. When the
ENTER key is pressed, “Buffer Reprint Enabled” is displayed and an
Intervention Required status is sent to the host. Pressing ENTER again
cancels the Buffer Reprint function and displays “Buffer Reprint Disabled.”
Early Print Cmpl
Allows the printer to send print (order) complete status to the host before the
printer is actually done printing all data. This option is valid only when the
printer is in DSC/DSE mode.
•
Disable
(default). The printer will suppress the Early Print Complete
response until all printing is complete.
•
Enable
. The printer will send an acknowledgment to the host when it is
able to accept more data.
NOTE:
When Early Print Complete is enabled and an error occurs, you may
lose data.
SCS Buffer Cntrl
This option is used in Coax LU1/SCS mode only.
•
Don’t Wait
(default). The printer does not wait for the job to be printed
before sending the print completion to the host.
•
Wait Until Done
. The printer waits for the job to print before sending the
print completion to the host.
This option speeds up the LU1 job printing for short jobs. If you select “Don’t
Wait,” there is a risk that you may not be able to recover the print job when the
printer has fault.
Cancel IGP/DCU
•
Enable
(default). Cancels all buffers when a job is put on hold from the
host or when the CANCEL key is pressed.
•
Disable
. Does not cancel any internal buffer in the printer when a job is
put on hold from the host or when the CANCEL key is pressed.