Printronix P7000 Cartridge Ribbon Printer - Manual (Page 236)

236
Chapter 4 LG Emulation
Horiz Forms
• Left Mgr 0.00 (default). This sets the left margin for the forms. You must
specify the left margin in 1/10 inch increments, from 0 to 13.1 inches. The
default value is 0. Press the right arrow to increase the value, left arrow to
decrease the value, and ENTER to change units. The margins will
automatically adjust so that the left and right margins do not cross each
other.
• Right Mrg 13.2 . This sets the right margin for the forms. You must specify
the right margin in 1/10 inch increments, from 0.1 to 13.2 inches. The
default value is 13.2. Press the right arrow to increase the value, left
arrow to decrease the value, and ENTER to change units. The margins
will automatically adjust so that the left and right margins do not cross
each other.
Autowrap
This parameter determines if text will wrap to the next line when the line of
text exceeds the right margin.
• No (default). Any print data received past the forms width setting is
discarded.
• Yes . An automatic carriage return and line feed is performed when data is
received past the forms width setting.
CR
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a Carriage Return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends line feeds to the printer.
• = CR (default). Does not insert an extra line feed after each carriage
return.
• = CR + LF . If this feature is enabled, each time the printer receives a
Carriage Return, it inserts an additional Line Feed code (hex 0A) into the
data stream. (Do not use this feature if the host computer sends Line
Feeds to the printer with each Carriage Return.)
LF
This parameter forces the printer to insert an automatic Carriage Return code
into the data stream whenever a Line Feed code occurs. This can be used in
most installations, but it is required if the host computer does not send
carriage returns to the printer.
• = LF (default). Does not perform an automatic carriage return. The next
print position will be the current print position of the next line.
• = CR + LF . Each time the printer receives a Line Feed, it inserts an
additional Carriage Return code (hex 0D) into the data stream. This
feature can be used in most installations, but it is required if the host
computer does not send Carriage Returns to the printer.