Printronix P7000 Cartridge Ribbon Printer User Manual
Page 315
Fault Messages
315
TCP PORT BUSY
Yes
Error message reported
by the Printer Manager
when ethernet interface
option is installed. The
network address given in
the printer properties was
reached, but the printer
port is busy.
Refer to the
Printronix
P7000
Maintenance Manual
.
TIP MISMATCH
Use Correct RBN
Yes
The incorrect cartridge
type is being used for the
printer.
Install the correct ribbon cartridge
type in the printer.
UNDEF INTERRUPT*
No
Undefined Interrupt.
Firmware error on
controller board.
Contact your authorized service
representative.
1
UNDFNED OPCODE*
No
Undefined Opcode.
Firmware error on
controller board.
Contact your authorized service
representative.
1
UNKNOWN RBN1
Install New RBN
Yes
The sensor detects a bar
code, but the ribbon
model is not permitted on
this printer.
Install a new ribbon.
UP DRV. SHORT*
No
Upper Driver Short.
Hammer driver circuits on
the boards shorted to
ground.
Cycle power to see if the message
clears, if not, contact your
authorized service representative.
1
WAITING FOR
ETHERNET ADAPTER
N/A
Status message: Appears
when the printer is first
powered on if the optional
Network Interface Card is
installed.
No action is required.
WELD NOT DETECT
See User Manual
No
The cartridge weld was
not detected.
Contact your authorized service
representative.
1
WELD RESET ERROR
See User Manual
No
The cartridge weld
circuitry lost power.
Contact your authorized service
representative.
1
WELD SNSR MISSING
See User Manual
Yes
The incorrect cartridge
type is being used for the
printer.
1.
Make sure that the correct
ribbon cartridge type is
installed in the printer.
2.
Contact your authorized
service representative.
1
1
Before contacting an authorized service representative, power off the printer, wait 15 seconds, then
power it back on and rerun your print job. If the message reappears, press ON LINE/CLEAR. If the fault
message still displays, then contact your authorized service representative.
Table 17. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation
Solution