SENA ProBee-ZE10 - Manual (Page 16)

16 ProBee-ZE10 User Guide Rev.1.5
2.1.5 Powering Development Board
Once all the installations are completed, please plug in the power connector using the included DC power
adapter. The RS_PWR, USB_PWR and BATT_EN jumpers should be all OPEN to use the DC power
adapter. Alternatively, the development board can be powered using batteries, or from the USB port or
through the RS232 port pin 9. In these cases, the power source jumpers should be set accordingly. For
details about the power source jumper settings, please refer to the section 6.3.1 Power.
Figure 2-6 Plugging DC Power Adapter
2.1.6 USB Driver Installation
In case the USB interface is used for the communication between the development board and the
computer, the corresponding software driver needs to be installed on the computer. Windows XP and later
versions already include the USB driver. When Windows asks for the location of the USB driver, you can
select the option to “install the software automatically” as shown in Figure 2-7. You can also choose to
install the driver from the CD included if the driver is not installed correctly for some reason.
Figure 2-7 USB Driver Installation