SENA ProBee-ZE10 User Manual
Page 80
80
ProBee-ZE10 User Guide Rev.1.5
AT+MULTICAST=0001,MSG03<CR>
OK
# Response
# send broadcast message(MSG04) to current network and the range is
determined by S35.
AT+BROADCAST=MSG04<CR>
OK
# Response
8.2.2
Data Mode
ATD<CR>
# enter the unicast mode using destination long address
OK
# Response
MSG05+++
# send data(MSG05) and leave data mode
ATD0000<CR>
# enter the unicast mode using 16-bit short address
OK
# Response
MSG06+++
# send data(MSG06) and leave data mode
ATD00019500002FDC40<CR>
# enter the unicast mode using 64-bit long address
OK
# Response
MSG07+++
# send data(MSG07) and leave data mode
ATM<CR>
# enter the multicast mode using destination group ID
OK
# Response
MSG08+++
# send data(MSG08) and leave data mode
ATM0001<CR>
# enter the multicast mode using 16-bit group ID
OK
# Response
MSG09+++
# send data(MSG09) and leave data mode
ATB<CR>
# enter the broadcast mode
OK
# Response
MSG10+++
# send data(MSG10) and leave data mode
AT+TRANSMITMODE=1<CR>
# set transmission mode
OK
# Response
ATZ<CR>
# Apply the change
OK
# Response
MSG11+++
# send data(MSG11) and leave data mode
ATO<CR>
# return to the current data mode
8.3
Security
AT+SECURITY=1<CR>
# set security level (ON)
OK
# Response