SENA ProBee-ZE10 - Manual (Page 49)

49 ProBee-ZE10 User Guide Rev.1.5
Figure 6-1 Development Board Layout
6.3 Development Board Hardware Descriptions
6.3.1 Power
There are four ways to supply power to the development board:

5V Power Adapter

USB Port

Batteries (AA 1.5V x 4)

RS232 Port (5V through 9
th
Pin)
The RS_PWR, USB_PWR and BATT_EN jumpers MUST be configured properly according to the way.
Table 6-1 shows jumpers configuration.
Table 6-1 Jumpers Configuration
RS_PWR USB_PWR BATT_EN
5V Power Port Open Open Open
USB Port Open Close Open
AA Batteries Open Open Close
RS232 Port Close Open Open