SENA ProBee-ZE10 User Manual
Page 38
38
ProBee-ZE10 User Guide Rev.1.5
OK<CR>
# Response
Send unicast msg
# Put the unicast message
+++
# Leave data mode
OK<CR>
# Response
ATD0000<CR>
# Enter the unicast mode using 16-bit node ID
OK<CR>
# Response
Send unicast msg
# Put the unicast message
+++
# Leave data mode
OK<CR>
# Response
ATD00019500002FDC40<CR>
# Enter the unicast mode using 64-bit IEEE address
OK<CR>
# Response
Send unicast msg
# Put the unicast message
+++
# Leave data mode
OK<CR>
# Response
AT+DESTLA=00019500002FDC40<CR>
# Set the destination IEEE address
OK<CR>
# Response
AT+TRANSMITMODE=1<CR>
# Set transmission mode to destination IEEE address
OK<CR>
# Response
ATZ<CR>
# Apply to change
OK<CR>
# Response
Send unicast msg
# Put the unicast message
+++
# Leave data mode
OK<CR>
# Response
AT+TRANSMITMODE=4<CR>
# Set transmission mode to sink node in the network
OK<CR>
# Response
ATZ<CR>
# Apply to change
OK<CR>
# Response
Send unicast msg
# Put the unicast message
+++
# Leave data mode
OK<CR>
# Response