SENA ProBee-ZE10 - Manual (Page 48)

48 ProBee-ZE10 User Guide Rev.1.5
6 Working with Development Kit
The ZE10 development kit provides a quick and easy way to be familiar with the ZE10 and test its
functionalities before you build your own PCB board to carry the ZE10. It is always recommended to start
with the ZE10 development kit before your own design.
6.1 Development Kit Contents
The development kit consists of ZE10 modules and development boards to carry them. The development
board provides RS232 and USB interface to interface with computers and/or your target devices. It
provides terminals for digital inputs/outputs and analog inputs, too. It also provides on/off switches and
LEDs to simulate and verify digital inputs/outputs. In addition, it has temperature and light sensor so you
can test more practical applications. Below is the list of the items included in the package.

ProBee ZE10 ZigBee OEM Module w/ Chip Antenna (1)

ProBee ZE10 ZigBee OEM Module w/ U.FL Connector (1)

ProBee ZE10 ZigBee OEM Module w/ RPSMA Connector (1)

3 dBi Dipole Antenna, RP-SMA Plug, Right-hand Thread (2)

12cm U.FL to RPSMA Cable, Right-Hand Thread (1)

Development Boards (3)

DC Power Adapters (3)

RS232 Serial Cable (3)

USB Cable (3)
6.2 Development Board Features
The development board is designed to provide convenient access to the ZE10 interface pins. The
development board provides external interfaces as below. Also Figure 6-1 shows the layout of those
interfaces of the development board.

RS232 Interface

USB Interface

3 Pre-defined Digital Inputs: Permit Joining, Factory Default Reset, Hardware Reset

8 User Configurable Digital Inputs

8 Digital Outputs with LEDs (Active High)

4 Analog Inputs

Temperature Sensor

Light Sensor