SENA ProBee-ZE10 - Manual (Page 55)

55 ProBee-ZE10 User Guide Rev.1.5
6.5 Configuration Example #2: 1 Coordinator and 2 End-Devices
Here is another example assuming different system configurations. This example can be described as
follows:

One ZE10 module acts as a coordinator and it is connected to a host computer via serial cable.

Two ZE10 modules act as end-devices.

Turn on/off the LEDs of the end-devices remotely through the coordinator
Figure 6-4 Example #2: 1 Coordinator and 2 End-Devices
6.5.1 Coordinator Configuration
Hardware configuration for the coordinator is as follows:

Set the HOST switch to UART

Connect a serial cable between a host computer and the coordinator
The AT commands for coordinator configuration is as follows:
AT+NODETYPE=1
OK
AT+PANID=7772
OK
ATZ
OK
6.5.2 End-devices Configuration
Hardware configuration for the coordinator is as follows:

Set the GPIO_OUT switch to LED_ON
The AT commands for the end-devices are as follows: