SENA ProBee-ZE10 - Manual (Page 56)

56 ProBee-ZE10 User Guide Rev.1.5
AT+NODETYPE=4
OK
AT+PANID=7772
OK
AT+GPIO=3333333333333
OK
AT+LONGADDR
0001950000000003
OK
ATZ
OK
6.5.3 Turning on/off the LEDs
The AT commands to control the LEDs are as follows:
AT+REMOTE=0001950000000003,AT+DIO=0000000000000
OK
AT+REMOTE=0001950000000003,AT+DIO=1111111111111
OK
6.6 Configuration Example #3: Light Sensor and Temperature Sensor
Here is an example sampling light sensor data and temperature sensor data. This example can be
described as follows:

One ZE10 module acts as a coordinator and it is connected to a host computer via serial cable.

One ZE10 modules act as a router.

Sampling light sensor data and temperature sensor data in many ways
Figure 6-5 Example #3: Light Sensor and Temperature Sensor